2 Inch TC - Hop Bong - Sight Glass

Named purely on its looks and not its function. The Hop Bong is a versatile pressurizable tri-clover accessory, capable of not only dry hopping oxygen purged hops into fermenters. But also as an inline carbonation/oxygenation accessory.

This particular sized tri-clover Hop Bong was designed for the FermZilla Tri-Conical and All Rounder Fermenters with the new Tri-Clover Adapted Pressure Lid. It can also be adapted to any 2" Tri-Clover port in your system to use either inline or as a dry hopping device.

Constructed from Nylon 12: An autoclavable, extremely robust, and chemical resistant engineering plastic.

Depending on how you set up your Hop Bong, the most common two fittings for the PCO Port are the duotight 6.35mm Red Gas Carbonation Cap, and the Red PRV Cap.

If you are after a full Hop Bong kit ready to go for you FermZIlla, you can get the 2" TC Hop Bong Upgrade Kit (everything except carb caps and a floating dup tube) or the Swedish Pumper (a complete kit that will replace your existing FermZilla lid)

Please note that the Hop Bong is not made from glass. It is made from special engineering plastic.

Recommend Setup (for all pressure capable FermZillas):

1 x KL28219 FermZilla Tri-Clover Pressure Lid (including PRV, Bottle caps, 2Inch clamp, seal, PCO1881/Tri clover adaptor)
1 x KL10788-Yellow Carbonation Cap PCO1881 (Yellow / Liquid)
2 x KL10788 Carbonation Cap PCO1881 (Red / Gas)
1 x KL17060 SS Float + 100cm Silicone Dip Tube + Dip Tube Hop Filter
1 x KL27564 FermZilla Tri-Conical - 2" x 2" Tri-Clover Butterfly Valve
1 x KL26079 2 Inch Tri-Clover - Hop Bong - Sight Glass
1 x KL20176 PCO1881 PRV Cap
1 x KL05333 Red PRV (35psi/2.5bar)
2 x KL03322 2 Inch Tri Clover Clamp
2 x KL03438 2 Inch Tri Clover Silicone Beaded Seal

Capacity in Hop Pellets
150g to 180g